This is topic Ridges on rollers in forum Film Handlers' Forum at Film-Tech Forum ARCHIVE.
To visit this topic, use this URL:
https://ft-forum.com/ft/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=1;t=003099
Posted by Christopher Duvall (Member # 284) on 02-17-2002, 05:56 AM:
I screened the print of Super Troopers Thursday night and all went well as planned. When I came in for the evening shift, the projectionist on duty quickly came to me and told me that that print got scratched during the second show of the day by one of the rollers below the analog sound head. Upon investigation, I discovered that the roller had a raised ridge down the center that was not there before. It was not any sort of build up, just plastic from the roller. Now for the question, what would cause the roller to produce the ridge down the center? I would like to prevent this from happening in the future.
BTW Brad, Film Guard once again came to the rescue. Covered those black scratches right up. Thank you and the Film Gods.
Posted by Dave Macaulay (Member # 813) on 02-17-2002, 09:19 AM:
I need a picture to understand this.
Roller plastic does not suddenly decide to reshape itself.
Some - many - rollers have a center ridge slightly smaller than the edges where the film touches. This prevents some problems with film buckling if the turning angle is too obtuse or the tension is too high. The film should never touch this ridge in normal operation.
This ridge will scratch the film if it does touch because the ridge's surface speed is slower than the film speed.
Posted by Stan Gunn (Member # 554) on 02-17-2002, 11:07 PM:
Maybe the film edge ran on the centre ridge and edge of roller,
I have seen this happen on some rollers. 
------------------
KALEE FOREVER. CARBON ARC, THE ONLY LIGHT FOR THE STARS!
ALL PARTS FOR VICTOR AND KALART VICTOR 16MM PROJECTORS.SERVICE TO 35 AND 16MM PROJECTION EQUIPMENT.
35MM sprockets made to order.
Posted by John Pytlak (Member # 331) on 02-18-2002, 02:08 PM:
AFAIK, some less expensive plastic rollers may be injection molded, and the ridge is a "seam" where the mold was separated, or where two sections were joined or welded together. Normally, any ridges, rough spots or "flashing" should be removed and polished. ------------------
John P. Pytlak, Senior Technical Specialist
Worldwide Technical Services, Entertainment Imaging
Research Labs, Building 69, Room 7525A
Rochester, New York, 14650-1922 USA
Tel: 585-477-5325 Cell: 716-781-4036 Fax: 585-722-7243
E-Mail: john.pytlak@kodak.com
Web site: http://www.kodak.com/go/motion