This is topic Christie part number needed. in forum Film Handlers' Forum at Film-Tech Forum ARCHIVE.
To visit this topic, use this URL:
https://ft-forum.com/ft/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=1;t=003482
Posted by Dave Cutler (Member # 515) on 05-24-2002, 05:20 AM:
So I haven't posted in a really long time, but I was away with the Army so forgive me.Anyway, I can't find a part number that I need in my manuals for a Christie Feedplate.
What I need is the little pressure pin that holds the center shaft to the feedpate to keep it from spinning. I haven't had much luck with the local hardware stores, but I will keep looking. If anyone knows the part number from Christie I would greatly appreciate it.
Posted by Joe Redifer (Member # 3) on 05-24-2002, 11:40 AM:
Have you tried downloading the manual? That should tell you. But my guess is that the part number ends with "-001".
Posted by Manny Knowles (Member # 1171) on 05-24-2002, 01:53 PM:
I haven't seen it in the manual...I had to order that part by just describing it...I think it's a "roll pin"------------------
~Manny.
Now...where was I ?
Leonard Shelby, MEMENTO.