Film-Tech Forum ARCHIVE: Dolby CP200 fader knob loose

This is topic Dolby CP200 fader knob loose in forum Film Handlers' Forum at Film-Tech Forum ARCHIVE.

To visit this topic, use this URL:
https://ft-forum.com/ft/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=1;t=006217

Posted by Christopher Seo (Member # 7) on 05-27-2004, 11:33 AM:

Help!

I'm setting up a CP200, and all seems in good order except the fader knob... it just spins freely. I tried tightening the nut under the cap but apparently that's not the problem. I can pull the knob out and the hollow shaft it's clamped onto comes with it. All I see underneath the knob is a short shaft in the middle of the vernier dial. The vernier dial seems to work.

Am I missing a part here? Is there any other adjustment in the base of the fader pot, or do I have to get a replacement?

Many thanks in advance!

Posted by Mark Gulbrandsen (Member # 72) on 05-27-2004, 09:18 PM:

The pot is broken internally and will have to be replaced. Seen this happen before.

Mark