Film-Tech Forum ARCHIVE: CP200 Accessory Unit power cable

This is topic CP200 Accessory Unit power cable in forum Film Handlers' Forum at Film-Tech Forum ARCHIVE.

To visit this topic, use this URL:
https://ft-forum.com/ft/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=1;t=006315

Posted by Mark Baldock (Member # 1018) on 06-30-2004, 02:13 AM:

I'm just about to upgrade our CP200 with an Accessory Unit prior to reinstating our magnetic sound capabilities. However, there was no DC power cable with the acc. unit. I have the connector housings and pins to make up a new cable, but can anyone confirm whether or not connector JM3 on the processor (power from processor to accessory unit) is wired the same way as JM2 (power to control unit from processor)? I presume it's a 1:1 straight through cable. I don't really want to accidentally swap the logic and amplifier supply rails or reverse bias the whole accessory rack! [Eek!]

Posted by Steve Guttag (Member # 268) on 06-30-2004, 11:23 AM:

It is the same pinout...pin for pin. The first cable from the power supply to the Processing unit has an extra wire...I believe for the delayed 24V.

Steve