Film-Tech Forum ARCHIVE: make-up table stuck on high speed

This is topic make-up table stuck on high speed in forum Film Handlers' Forum at Film-Tech Forum ARCHIVE.

To visit this topic, use this URL:
https://ft-forum.com/ft/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=1;t=006583

Posted by Ramin Hashemi (Member # 2694) on 09-17-2004, 09:14 PM:

My Christee make up table is stuck on high speed. This is during breakdown and buildup, so I am thinking it must be the card. Anyone have any idea. thanks
Ramin

PS, I did replace the card, and all is well now. thanks
Ramin

[ 09-18-2004, 04:51 PM: Message edited by: Ramin Hashemi ]

Posted by Tony Bandiera Jr (Member # 2365) on 09-17-2004, 09:25 PM:

Ramin:

Yep, sounds like the control card has shorted out. Some more info if you please:

Is it for Autowind 2 or Autowind 3? (They are NOT interchangeable)

Look under the table, is it the round control board? Or is it the way old style with the platter deck control cards under the front panel?

Is the MUT cable and platter receptacle in good condition? Has anyone tried to put a new screw in the MUT's cable connector cover? (I've had these short out in a few cases.)

That info would help us to help you! [thumbsup]

Posted by Ramin Hashemi (Member # 2694) on 09-18-2004, 04:10 PM:

It is an Autowind 3 with a round control card. I am not sure what a MNT cable is, but everything looks ok. Could it be the high and low pots on the control card, and if so ho do I adjust them.

thanks for your help
Ramin