Film-Tech Forum ARCHIVE: Proper wiring for Kniesley auto strike board

This is topic Proper wiring for Kniesley auto strike board in forum Film Handlers' Forum at Film-Tech Forum ARCHIVE.

To visit this topic, use this URL:
https://ft-forum.com/ft/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=1;t=007191

Posted by Brad Allen (Member # 470) on 05-14-2005, 09:37 PM:

I have a l-1745-3 auto strike board.
What is the proper wiring of this to install into a Xenex 1 lamphouse.
Which pair of terminal screws on the auto strike board goes to the leads that measures the power supply voltage? I'm sure polarity matters so Positive & negative go to which?

Then I bet I can figure out where the other two terminal connections from the auto strike board go from there. [Wink]

Thanks, any help appreciated.