Film-Tech Forum ARCHIVE: Maxi 10CL Termination Diagram

This is topic Maxi 10CL Termination Diagram in forum Film Handlers' Forum at Film-Tech Forum ARCHIVE.

To visit this topic, use this URL:
https://ft-forum.com/ft/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=1;t=007278

Posted by Richard May (Member # 2627) on 06-20-2005, 08:25 PM:

Hey everyone. Does anyone know the terminations for the Xetron Maxi10CL. It is not the same as the 10X. Any help would be great. Thanks.

Posted by Gregory N. Jones (Member # 805) on 06-21-2005, 09:23 AM:

Richard,

Terminations for the MAXI10C are as follows:

1: Remote start
2: Remote proj. run light
3: Remote alarm out
4: Ground
5: Remote Proj. stop light
6: not used
7: not used
8: Dimmer #1 feed
9: Dimmer #1 raise
10: Dimmer #1 lower
11: Dimmer #2 feed
12: Dimmer #2 raise
13: Dimmer #2 lower
14: Ground
15: Failsafe
16: Outboard cue
17: Inboard
18: hold for interlock
19: not used
20: not used
21: Non-sync 120 VAC out
22: not used
23: 120 VAC feed
24: 120 VAC neutral
25: Ground
26: Proj. motor
27: Proj. motor
28: C.O. feed
29: C.O open
30: C.O. close
31: Remote proj. stop light
32: 12 VAC
33: Ground
34: Stereo
35: Stereo
36: Masking feed
37: Masking flat
38: Masking scope
39: Xenon lamp
40: Xenon lamp
41: Exciter lamp
42: Exciter lamp
43: Non-sync
44: Non-sync

This is the information I have available for the MAXI10C. If you need anymore information or help give, John Walsh a call @ 203-270-1100.

Hope this helps!

Gregory Neu Jones
Neumade Products Corp.

Posted by Richard May (Member # 2627) on 06-21-2005, 08:12 PM:

Thanks Gregory and thanks John Walsh. All of your info was just what I needed. Thanks again.