Film-Tech Forum ARCHIVE: Prt Ultra and platter reel?

This is topic Prt Ultra and platter reel? in forum Film Handlers' Forum at Film-Tech Forum ARCHIVE.

To visit this topic, use this URL:
https://ft-forum.com/ft/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=1;t=007820

Posted by Jorge Canales (Member # 3626) on 02-17-2006, 12:37 PM:

Hi

I was in need of some advice. Do you guys recommend the use of the goldberg platter reel with this rewind table? Do you think the table is sturdy enough to handle the weight? Are any of you specifically using this combination?

Thanks

Posted by Monte L Fullmer (Member # 2797) on 02-21-2006, 11:52 PM:

I would make sure that the support columns on the motor end are securely anchored down with the allens (you could drill a dimple in the support columns for the allen to really get a grab on). If using that reel on the free end, make sure that the columns are also secure.

Make sure that the spindles in the adapters are not bent and sturdy..then take it slow on the wind.

-Monte

Posted by John Walsh (Member # 168) on 02-22-2006, 11:50 AM:

I think Monte's ideas are good, but I would like to add one comment... The PRT Ultra table was designed to accomodate a 'one hour reel.' The exact weight of a 'one hour reel' varies, but is probably about 25-30 pounds. A Goldberg platter reel can hold more than 2 hours of film. With trailers, ads, and all the other 'important consumer messages', you could have upwards of 70 pounds on that platter reel. Or, to put it another way....

You could place more than double the intended load on the spindles.

You can adjust the tilt of the spindles; make sure they are level. I would follow Monte's ideas, in the order he listed. Especially the last part! [Smile]