Film-Tech Forum ARCHIVE: Need part# for Component Engineering ASR-30S LED plug

This is topic Need part# for Component Engineering ASR-30S LED plug in forum Film Handlers' Forum at Film-Tech Forum ARCHIVE.

To visit this topic, use this URL:
https://ft-forum.com/ft/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=1;t=009183

Posted by Tim Reed (Member # 137) on 03-12-2008, 10:04 PM:

I need the part number for the LED connector plug for an ASR-30, in an SH-1000. This is the tiny 2-conductor compression terminal where the wires from the power supply are connected. It plugs into the back of the LED bracket in the soundhead. I'm dealing with a used unit in an installation, and the one I have fell apart.

Thanks!

Posted by Mark Gulbrandsen (Member # 72) on 03-12-2008, 10:34 PM:

Tim,

If this is the version with the thin flex pcb then it'll have to come from C.E., but you may be able to hot wire it temporarily for the time being with some 24 gauge wire. Either way it might be faster to just get em from them.

Mark

Posted by Tim Reed (Member # 137) on 03-13-2008, 10:12 AM:

It's some kind of phenolic plug. Very small screw terminals. I have it wired, but I'm not confident the terminals won't later pop out of the housing.

Thanks!

Posted by Mark Gulbrandsen (Member # 72) on 03-13-2008, 10:21 AM:

Yea, now I remember the part you're talking about... I highly reccomend that you call C.E. to get it the quickest... it'll certainly be faster than trying to figure out which connector it is in the Newark or Allied catalog...

Mark

Posted by Tim Reed (Member # 137) on 03-13-2008, 02:08 PM:

That's just it. I need CE's part number, so I can send in a purchase requisition for it. They don't have parts books online that I can find anywhere.

Thanks again.