Film-Tech Forum ARCHIVE: Strong eCNA 150 Password help

This is topic Strong eCNA 150 Password help in forum Film Handlers' Forum at Film-Tech Forum ARCHIVE.

To visit this topic, use this URL:
https://ft-forum.com/ft/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=1;t=010117

Posted by William T. Parr (Member # 677) on 10-07-2009, 01:05 PM:

Howdy all,

I have 3 Strong eCNA 150's that I am trying to reconfigure the IP address and Subnet mask on. Following the directions in the manuals availbale, it only states that the password is non configurable. It never says what the default password is or where to locate it. Would anyone here happen to know what it might be? for reference the screen I am seeing can be found on page 19, figure 7 of the Installation/Operation manual here on Film-tech.

Posted by Chris Slycord (Member # 4239) on 10-07-2009, 02:01 PM:

http://www.strong-cinema.com/ContactUs.aspx

[Wink]

Posted by William T. Parr (Member # 677) on 10-07-2009, 02:42 PM:

Yeah. I been there already, They were helpful with answering a few questions, but the last couple I sent and asked I was told that the folks I buy my parts through could help me, in other words I got the impression that since I was not a known technician or a direct supplier of thier stuff, they really did not want to deal with me and instead deferred me to my dealer for help. That is why I am here. I also have emails out to my Strong Cinema dealer trying to get an answer.

Posted by Mark Gulbrandsen (Member # 72) on 10-07-2009, 05:24 PM:

Try 31415. Thats what it is on the Eprad Ultimation.

Mark

Posted by Jesse Montoya (Member # 5450) on 10-08-2009, 12:46 AM:

31415 is the default.
(beginning of Pi)