This is topic Looking for manual for 35mm Intercine in forum Film Handlers' Forum at Film-Tech Forum ARCHIVE.
To visit this topic, use this URL:
https://ft-forum.com/ft/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=1;t=010433
Posted by Paul Gordon (Member # 3320) on 04-20-2010, 04:22 PM:
Anyone know where I can find a manual or PDF for a 35mm Intercine (flatbed)? any model would do..
Thanks
Posted by System Notices (Member # 2357) on 06-20-2011, 08:31 AM:
It has been 425 days since the last post.
Posted by Chris Spencer-Lowe (Member # 6317) on 06-20-2011, 08:31 AM:
Hello Paul,
Chris here from Halifax.
Just wondering if you found a manual for your intercine ?
We too are looking for one.
Posted by Paul Gordon (Member # 3320) on 06-20-2011, 10:30 AM:
Yes we found one...in fact a bunch, which model do you have?
-paul
Posted by Chris Spencer-Lowe (Member # 6317) on 06-28-2011, 12:01 PM:
Wonderful ! They are exceedingly difficult to find.
We have a 16/35mm six plate. That ID plate reads:
LAINATE (MI)
M.613/S. bi.P.
N. 2884
We are in Halifax, Nova Scotia
Posted by Paul Gordon (Member # 3320) on 06-29-2011, 12:06 PM:
OK i'll see if I have one for you.
Posted by Chris Spencer-Lowe (Member # 6317) on 07-07-2011, 10:53 AM:
Hello Paul,
Have you managed to find a manual we could have?
Thanks in advance.
Posted by Paul Gordon (Member # 3320) on 07-15-2011, 12:27 PM:
I looked through our manuals we don't seem to have your model, but I'm sure many are very similar. Can you email me a picture of your flatbed? Then I'll narrow it down.
Posted by Chris Spencer-Lowe (Member # 6317) on 07-18-2011, 01:10 PM:
A photo of our Intercine.
Thanks
Posted by Emiel De Jong (Member # 4225) on 07-23-2011, 04:35 AM:
I have the threading diagrams for that model; I could have them scanned or copied if that helps. What I don't have is a service manual; I could use one myself since speed is low on my machine; something to do with the motor control board I guess; I renewed some big capacitors but that did not make any difference...