Film-Tech Forum ARCHIVE: Help ID'ing this?

This is topic Help ID'ing this? in forum Film Handlers' Forum at Film-Tech Forum ARCHIVE.

To visit this topic, use this URL:
https://ft-forum.com/ft/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=1;t=010839

Posted by Jonathan Peirce (Member # 5364) on 03-12-2011, 06:35 PM:

I am trying to D/L a manual for this, but I am not sure what model it is... any help is appreciated!
Thanks!
JP

Posted by Jim Cassedy (Member # 4115) on 03-12-2011, 08:10 PM:

The back panel on my Xetron XH-4000 looks exactly like
the one in your photo. There may be several models with
identical or similar back panels though.

There should be model a number plate on the FRONT of
the lamphouse. If you were standing directly in front
of the "hole" where the light comes out, it should be
rivited to the lower right corner of the front housing.

(Unless yours has fallen off. . . )

Posted by Louis Bornwasser (Member # 3063) on 03-12-2011, 09:39 PM:

Be advised that wiring varied all-over-the-place on these. Factory changed some and the installation engineer changed some. I usually rewire to look like the Super Lumex, myself.

Probably a 2000 watt system if in an indoor. Measure the length of the box before you call anyone.

Desireable upgrade: add a zener diode instead of the pot for igniter reliability; later models have this. Louis

Posted by Aaron Sisemore (Member # 145) on 03-14-2011, 01:09 AM:

As mentioned, its most likely a XH-2000 .