Film-Tech Forum ARCHIVE: Cinema Monitor Panel pinout?

This is topic Cinema Monitor Panel pinout? in forum Film Handlers' Forum at Film-Tech Forum ARCHIVE.

To visit this topic, use this URL:
https://ft-forum.com/ft/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=1;t=011185

Posted by Jim Henk (Member # 3628) on 03-16-2012, 05:04 PM:

I chanced on an Entertainment Engineering Inc. Model 90.0001 MP Cinema Monitor Panel, and the cable pinout is a little cryptic. Apparently they're out of business now. (at least their website is gone, and 411 says no listing...)

Anybody ever seen one of these and maybe even seen a manual for it? Not even sure if the inputs(?) are line level or speaker level, not to mention decode their pin nomenclature.

Thanks!

Posted by Louis Bornwasser (Member # 3063) on 03-16-2012, 08:41 PM:

Entertainment Engineering was me! The inputs are meant for amp outputs. The pot on the board is in series with the pot on the front.

One black wire is chassis ground. The rest are various speaker inputs: left hf, left lf, etc.

I will look at a drawing to see if any further info is available.

Runs on 12 volt AC. 4 watt amp, 2 watt power supply. "Can't explode!" Does sound good and is LOUD compared to most monitors. Louis

Posted by Jim Henk (Member # 3628) on 03-17-2012, 12:35 AM:

Hi Louis,
Tried to email you on this off-line, but louis@haddentheatresupply.com bounces back as an unknown site. Is there a better email address?

Posted by Louis Bornwasser (Member # 3063) on 03-17-2012, 08:36 AM:

Use the film-tech site email. Louis

Posted by Steve Guttag (Member # 268) on 03-17-2012, 02:24 PM:

Yeah... it is posted right under the sign

"For a good time, email: louis at..."