Film-Tech Forum ARCHIVE: Debrie HDC 35mm Editing/ Inspection Table Speed Fault.

This is topic Debrie HDC 35mm Editing/ Inspection Table Speed Fault. in forum Film Handlers' Forum at Film-Tech Forum ARCHIVE.

To visit this topic, use this URL:
https://ft-forum.com/ft/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=1;t=011757

Posted by Tom McGarrity (Member # 7320) on 12-11-2014, 10:06 AM:

My table will only run back or forward at speed, not at 24 or 25 fps. Does anyone have knowledge of these ?

Posted by Tony Bandiera Jr (Member # 2365) on 12-12-2014, 08:37 PM:

Not familiar with the specific table, but in general speed controls that fail in "high speed" mode means one thing: the control triac that drives the motor has shorted out.

Posted by Tom McGarrity (Member # 7320) on 12-14-2014, 09:41 AM:

Thanks Tony.