Film-Tech Forum ARCHIVE: Cinemeccanica V8 aperture plates

This is topic Cinemeccanica V8 aperture plates in forum Film Handlers' Forum at Film-Tech Forum ARCHIVE.

To visit this topic, use this URL:
https://ft-forum.com/ft/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=1;t=012442

Posted by Markus Lemm (Member # 3456) on 06-12-2019, 01:17 PM:

I am looking for a set of unfiled Scope / Flat aperture plates for a Vic8. And a set of 1.37 plates would be great too.

Please send me a message through the forum.

Markus

Posted by Bill Hall (Member # 10520) on 06-13-2019, 09:02 PM:

HI I acquired a vic 8 projector from the Collingwood Galaxy theater a number of months ago . I did not get an aperture plate with the projector and not able to run it as it is 220 three phase. The people that work there a young lad was going to keep three of these projectors . If you contact the theater perhaps they can direct you to the person that may have parts . If you wanted my projector I am willing to give it to you if you would like it .
Bill

Posted by Gordon McLeod (Member # 33) on 06-17-2019, 12:23 PM:

there are two different plates for that machine a 3 hole and a two hole

Posted by Markus Lemm (Member # 3456) on 06-17-2019, 02:01 PM:

I'm looking for the 3 hole.

I found a 1.37/1.85/2.0 plate that I can file out to fit. Another one of those would be awesome. Its the /24 serial number.

I'll try the Collingwood Galaxy and see if they are willing to sell.

Hey Bill, say 'hi' to Owen Sound for me. I went to high school at OSCVI.

Markus