Film-Tech Forum ARCHIVE: NEC-NC2000C- "Stuck" In Auto-Strike Mode

This is topic NEC-NC2000C- "Stuck" In Auto-Strike Mode in forum Digital Cinema Forum at Film-Tech Forum ARCHIVE.

To visit this topic, use this URL:
https://ft-forum.com/ft/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=16;t=001588

Posted by Jim Cassedy (Member # 4115) on 08-05-2013, 05:02 PM:

Somebody was using the NEC 2000C in the screening room I work at over the weekend when I wasn't there.
Im guessing that when they were through, they didn't shut it down properly and now, when you power it up,
instead of going into 'standby' mode, the lamp strikes.

>Does anyone know how to reset it so that it powers up normally and goes into 'standby' without the lamp going on?

Posted by Stefan Vogels (Member # 5573) on 08-05-2013, 05:18 PM:

Yes, just put the projector back in standby and give the command to put the xenon lamp off. The projector will display Standby - Lamp off when it is fixed. Where it now says Standby - Lamp on

Best regards,
Stefan

Posted by Justin Hamaker (Member # 2165) on 08-05-2013, 06:45 PM:

If you have access to the DCC software, I think lamp button will be On even when the projector is in standby. Just press the off button for the lamp.

Posted by James Ness (Member # 4631) on 08-25-2013, 04:00 AM:

in Standby mode, just push and hold the 'lamp' button and the display will change from 'lamp on' to 'lamp off'

then it won't strike once you power it on