Film-Tech Forum ARCHIVE: IMS1000 NTP configuration.

This is topic IMS1000 NTP configuration. in forum Digital Cinema Forum at Film-Tech Forum ARCHIVE.

To visit this topic, use this URL:
https://ft-forum.com/ft/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=16;t=002332

Posted by Fevzi Genc (Member # 2940) on 06-15-2015, 02:27 PM:

Hello,

Are there any documentation shows how to configure NTP server on IMS1000.

Thanks,

Posted by Marco Giustini (Member # 4544) on 06-15-2015, 03:38 PM:

control panel / time

The unit must be able to access the internet of course.

Posted by Dave Macaulay (Member # 813) on 06-15-2015, 03:52 PM:

It is a tab in control panel / time.
You also need to set up a DNS server in the network properties. If it's going through an internet router you generally just use the router address. If you use DHCP all settings will be automatic but the server address will be dynamic, not static: you can set up most routers to use DHCP and reserve the server address by MAC address. I would use a static address if possible.

Posted by Fevzi Genc (Member # 2940) on 06-16-2015, 12:55 PM:

Thanks Dave, Marco,

I am using static IP. How can i setup DNS server. There is no choice in control panel tab.

Posted by Marco Giustini (Member # 4544) on 06-16-2015, 04:21 PM:

control panel / networking

Are you authorised to play with that system?

Posted by Fevzi Genc (Member # 2940) on 06-17-2015, 10:51 AM:

Don't worry Marco, I am authorized person. There is no field in control panel/networking to input DNS server adress.

Thanks,

Posted by Marco Giustini (Member # 4544) on 06-17-2015, 04:38 PM:

ehm... you're right!

The installation manual mentions a way to manually 'rescue' the IP configuration and also mentions how to add DNS servers but apparently there's no DNS field under networking!

How bizarre. [Smile]

I'm stuck!