Film-Tech Forum ARCHIVE: Sony SRX-R510 / XCT-S10

This is topic Sony SRX-R510 / XCT-S10 in forum Digital Cinema Forum at Film-Tech Forum ARCHIVE.

To visit this topic, use this URL:
https://ft-forum.com/ft/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=16;t=003486

Posted by Ronn Mesias (Member # 8292) on 11-03-2018, 02:04 PM:

Is anyone know how to change the IP address of sony SRX-R510.

and how/what are the message to call the automation of projector thru SMS XCT-S10 (ie.douser,lamp,channel) a list is highly appreciate.

We managed to add cp750 and jnior call.

Thanks and more power!

Posted by Carsten Kurz (Member # 5396) on 11-03-2018, 03:52 PM:

You need a setup or admin account to do these changes in the network tab: 'Configuration->System->Network

You can not access projector macros externally through an automation, if that is what you are asking for. If you are referring to these EEC macros, these are network automation commands you can send FROM the Sony to external networked devices (e.g. audio processors). They can be set up in the same network config page where you can change the network configuration.

You would not need to set up EEC command to control a CP750 - the S10 has a control library activated for a CP750 per default. You only need to configure the CP750 IP address unter the same network tab.

You should try to dig up the installation manual and read through it, it has all these aspects covered.

- Carsten

Posted by Ronn Mesias (Member # 8292) on 11-04-2018, 01:10 AM:

Thanks for the information Carsten Kurz. [thumbsup]

We dont have any issue in cp750 and other automation device.

we getting hard time for the projector macros. we have GDC TMS, only projectors macros is missing. [Confused]

Posted by Carsten Kurz (Member # 5396) on 11-04-2018, 06:22 AM:

You need to talk to GDC then. The only way to do it without direct TMS support is to build these cues into dedicated short automation-only playlists and run these from the TMS.
These remote Cues of course do exist, as the S10 uses them towards the projector network interface. But looks as if GDC did not implement them so far, or didn't get along with Sony about it.

- Carsten

Posted by Ronn Mesias (Member # 8292) on 11-04-2018, 07:32 AM:

Hi Carsten,

Thanks for your effort and time replying in my query.

one last shot, 😊 can you help me to get API of XCT-M10.