Film-Tech Forum ARCHIVE: NEC NC1200C Service door remarriage (Tamper error)

This is topic NEC NC1200C Service door remarriage (Tamper error) in forum Digital Cinema Forum at Film-Tech Forum ARCHIVE.

To visit this topic, use this URL:
https://ft-forum.com/ft/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=16;t=003580

Posted by Ben Hodson (Member # 10724) on 02-05-2019, 06:56 AM:

How do I go about remarrying the service doors on my NC1200C? Have read about 1111 when logged into service mode but nowhere asks me to log in.

Thanks in advance

Posted by Mark Gulbrandsen (Member # 72) on 02-05-2019, 08:56 AM:

Logging into service mode resets the service door after you changed a lamp or pulled the sides off for some reason. If you need to remarry and have a legacy input module then that is done in "Setup" in DCC. If you have an IMB server that has to be remarried because you pulled it out, then that is normally done in the IMB Servers firmware.

Mark

Posted by Leo Enticknap (Member # 534) on 02-05-2019, 09:32 AM:

Per this site's rules, we are not supposed to post login credentials here.

As Mark points out, there are actually multiple separate security clear procedures you need to do: one for the projector itself, and the other for the IMB/IMS, and/or Enigma card (three procedures if you have both option slots in use, and have both and IMB/IMS and an Enigma).

If you email cinema.support [at] necdisplay.com, and tell them what make and model of IMB or IMS you're using, and if you have an Enigma card or not, I'm sure that they'll be able to give you the information that you need.