Film-Tech Forum ARCHIVE: Error in ICP

This is topic Error in ICP in forum Digital Cinema Forum at Film-Tech Forum ARCHIVE.

To visit this topic, use this URL:
https://ft-forum.com/ft/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=16;t=003758

Posted by Edgar Familiar Erazo (Member # 8521) on 08-03-2019, 10:25 AM:

Good morning, have a problem when it comes to icp, restart the Barco projector dp2k 23b after a few minutes it turns red with the following message on the communicator (ti - icp: read systems status failed), any recommendation you can give me, Greetings.

Posted by Steve Guttag (Member # 268) on 08-03-2019, 10:43 AM:

Reseat the ICP module and pray. You'll need to clear the security error (Dallas key plus code) but even without that, you'll know if the ICP is alive or not.

Posted by Stephan Shelley (Member # 8587) on 08-03-2019, 05:00 PM:

You might try reseting the clock. I have had ICP errors after replacing the ICP clock battery on Barcos. I reset the clock and rebooted and all was well.

Posted by Leo Enticknap (Member # 534) on 08-04-2019, 02:29 PM:

Deceased ICP clock battery? Trying a new one is a helluva lot cheaper than a new ICP.

Posted by Steve Guttag (Member # 268) on 08-04-2019, 05:14 PM:

I'd definitely give it a shot. Leo is correct...particularly at Cinionic parts prices, nowadays.

Posted by Edgar Simoes (Member # 10255) on 08-07-2019, 04:16 PM:

Hi I was having the same problem, and I chek the logs that show me a temperature problem. If the FPGA temperature is too hi, the ICP fail. I recommend that you clean the air filters in front of fans. Good luck.