Film-Tech Cinema Systems
Film-Tech Forum ARCHIVE


  
my profile | my password | search | faq & rules | forum home
  next oldest topic   next newest topic
» Film-Tech Forum ARCHIVE   » Operations   » Film Handlers' Forum   » Hey, you, you rule! (AKA: Praising good film handlers) (Page 6)

 
This topic comprises 6 pages: 1  2  3  4  5  6 
 
Author Topic: Hey, you, you rule! (AKA: Praising good film handlers)
Sean McKinnon
Phenomenal Film Handler

Posts: 1712
From: Peabody Massachusetts
Registered: Sep 2000


 - posted 06-08-2008 11:16 AM      Profile for Sean McKinnon   Author's Homepage   Email Sean McKinnon   Send New Private Message       Edit/Delete Post 
would that be the Landmark Kendall Square cinema in Cambridge, Ma? I have been to that theatre on service calls and have to say it is a very clean and well maintained booth. Landmark also put some decent equpiment in when they built the place including two projectors, and consoles on thier biggest screen. I don't think they are set up for change over I think one is just a spare.

 |  IP: Logged

Thomas Pitt
Master Film Handler

Posts: 266
From: Leeds, West Yorkshire, UK
Registered: May 2007


 - posted 06-08-2008 11:37 AM      Profile for Thomas Pitt   Email Thomas Pitt   Send New Private Message       Edit/Delete Post 
I must suggest the film handlers at the Bradford Cineworld - this cinema has some of the best presentation I've ever seen! I've never once had to complain about the picture or sound; they do manual starts whenever possible (so they can check focus and framing), and most of the time the picture and sound are the best I've seen in a multiplex!
I have complained about other things though - like the buzzing on the front channels and disabled douser I mentioned in other threads, but that's not really the film handler's fault.

Also, all three single-screen cinemas (including the IMAX) in the National Media Museum, Bradford. Although they use platters, everything is done manually (curtains, start/finish, turret changeover), and I've never once seen a bad presentation due to incompetent projectionists [Big Grin]

 |  IP: Logged

Jon Miller
Jedi Master Film Handler

Posts: 973
From: San Diego, CA, USA
Registered: Sep 1999


 - posted 06-08-2008 01:43 PM      Profile for Jon Miller   Email Jon Miller   Send New Private Message       Edit/Delete Post 
quote: Sean McKinnon
would that be the Landmark Kendall Square cinema in Cambridge, Ma?
No, it is the Ken Cinema in the Kensington neighborhood of San Diego, CA. This theatre was, for a long while, the only full-time movie house in San Diego County still running changeovers and carbon arcs. Their projectionists took pride in keeping their vintage equipment in good shape and putting on a good show.

I haven't gone to a movie there in several years but I read somewhere on the Web that the Ken threw in the towel and replaced their Super Simplexes and Peerless Magnarcs with platters and xenon and put one of their old projectors out in the (cramped) lobby on display. An end of an era, indeed. [Frown]

 |  IP: Logged

Mike Olpin
Chop Chop!

Posts: 1852
From: Dallas, TX
Registered: Jan 2002


 - posted 06-08-2008 01:57 PM      Profile for Mike Olpin   Email Mike Olpin   Send New Private Message       Edit/Delete Post 
Yes, that is true. The story I heard was that the carbon rods were expensive and getting hard to find. I used to enjoy sitting in the very back and hearing the faint sound of reel end bell. By and large, the Landmarks in San Diego do a good job.

 |  IP: Logged

Chad M Calpito
Master Film Handler

Posts: 435
From: San Diego, CA
Registered: Apr 2006


 - posted 06-08-2008 05:10 PM      Profile for Chad M Calpito   Author's Homepage   Email Chad M Calpito   Send New Private Message       Edit/Delete Post 
I, too, heard about them switching over to being a Xenon/Platter house via e-mail from them. It's been a long time since I've been to that theatre, but, they always put on a good show.

 |  IP: Logged

System Notices
Forum Watchdog / Soup Nazi

Posts: 215

Registered: Apr 2004


 - posted 11-22-2009 10:10 PM      Profile for System Notices         Edit/Delete Post 

It has been 532 days since the last post.


 |  IP: Logged

Jeremy Jorgenson
Phenomenal Film Handler

Posts: 1002
From: Chicago, IL, USA
Registered: Feb 2005


 - posted 11-22-2009 10:10 PM      Profile for Jeremy Jorgenson   Author's Homepage   Email Jeremy Jorgenson   Send New Private Message       Edit/Delete Post 
Print #0003 of Serious Moonlight had been played by I'm guessing at least three other places before I assembled it (judging by different splicing tapes I saw on the print - I know that doesn't necessarily, make it the case, but for sure it was assembled at least twice before it got to me). Just wanted to mention that despite the left over splicing tape at the heads & tails, the print was in very good condition. The picture looked good on screen and the audio sounded good too - so, thanks!

 |  IP: Logged



All times are Central (GMT -6:00)
This topic comprises 6 pages: 1  2  3  4  5  6 
 
   Close Topic    Move Topic    Delete Topic    next oldest topic   next newest topic
 - Printer-friendly view of this topic
Hop To:



Powered by Infopop Corporation
UBB.classicTM 6.3.1.2

The Film-Tech Forums are designed for various members related to the cinema industry to express their opinions, viewpoints and testimonials on various products, services and events based upon speculation, personal knowledge and factual information through use, therefore all views represented here allow no liability upon the publishers of this web site and the owners of said views assume no liability for any ill will resulting from these postings. The posts made here are for educational as well as entertainment purposes and as such anyone viewing this portion of the website must accept these views as statements of the author of that opinion and agrees to release the authors from any and all liability.

© 1999-2020 Film-Tech Cinema Systems, LLC. All rights reserved.