DCI content most definitely is in XYZ. So with the input now being in RGB mode, you definitely would expect odd colors on the screen... Maybe the "auto" mode is smart enough to detect the color mode mismatch and silently fixes it? But this is rather odd. Are you sure you didn't reset the scaling too? Because I suspect that that's where the problem is.
-
-
Hi All,
Update,
While using RGB_Auto, i noticed the colors just drifted a lil bit, however BARCO recommended to reset the Macros files, i did look deeper and found out one of the tech entered values on the PCF file which messed up the file, what i did, i just exported the PCF from other projector and imported it on the unit and issue is fixed, cuz if i did what BARCO said i will have to redo a lot of things.
Thank you Guys for the helpComment
-
Good. Barco won't know what's been messed with and will recommend a procedure that fixes all the files. Just trying to cover all bases.
I had one case where a "technical whiz" operator got the service password and went wild trying to do something special. I had a backup from before he did his magic but had to install a Barco base clone, recover the ICP, and install the backup clone - then do some minor changes needed from stuff done after I took the backup. Of course lens files were useless but they don't take long to revise.
If only that one PCF was modified, good on you for finding and fixing it!Comment
Comment