BluRay into CP750 common practice?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Marco Giustini
    Film God
    • Jan 2020
    • 1191
    • Reading, UK

    #16
    I'm not sure I agree on Stefan's view here. You're saying a cheapo AVR/TV can deal with a blu ray playback but the AP20/25 cannot? The HDMI board has separate firmware which can be updated independently, I honestly feel it's just a matter of fixing in software whatever is wrong with that simple and basic feature - switching to AC3 when TrueHD is not available.

    HDMI revision shouldn't really affect basic sound playback IMHO.

    Comment

    • Ryan Gallagher
      Film God
      • Nov 2022
      • 2912
      • Austin, Texas, USA

      #17
      Yeah of course it comes down to market, room use cases, and generation of cinema equipment installed. Stephen's approaches are 100% valid in certain installations.

      Converting 2K discs to DCP is not too difficult and my preferred method too, provided enough advanced time. But sometimes they show up with clients an hour before the show.

      Being a mixed theatrical / cinema venue, with an older CP2220 and no IMS/IMB... and a CP750. Handling BluRay audio directly off the player into the processor has been the norm in this room (because the Oppo gives the needed features). I was just a little surprised to become aware of the compromise way it was configured favoring "it will just work and have sound" to actually processing a preferred bitstream mix that is available on most discs.

      We also have a seamless video switcher to deploy or not deploy in the chain, default is it exists in the HDMI path before conversion to SDI for the long run to the projector's DVI input. We don't ask HDMI to carry audio past all those devices. If we had a HDMI enabled IMB/IMS it might be a different story.

      To complicate things we have a consumer 4K Blu-Ray player (for when those discs are required) that used to work fine next door with the AP20, but I need to prove it out again over here. It might have it's own shortcomings relative to CP750 handling the audio directly.

      Adding an nice consumer AVR receiver that supports line level analog outputs would be one easy path to get all of it working without many button presses or repatching... as our DB25 multichannel analog input is unused on this CP750 install, but the needs are rare enough and the install (and building) has a shelf life currently, such purchases are unlikely to be approved.

      Comment

      Working...